700R4 Road Race 1988 & Up :: 700R4 :: General Motors :: GM Transmissions

Printable version

Categories

Bestsellers

1. 700R4 Pro Street
2. 700R4 Street/Strip Transmission
3. 700R4 Heavy Duty Transmission 1988 & Up
4. 700R4 Road Race 1988 & Up

Manufacturers

Vigilante Torque Converter
Stallion Torque Converter
Edge Torque Converter
Continental Torque Converters
TransGo

Special

Gift certificates

Help

Pro-Built Automatics :: GM Transmissions :: General Motors :: 700R4 :: 700R4 Road Race 1988 & Up

700R4 Road Race 1988 & Up

Road Race 700R4: Starting at the "Front Pump", new (late design) seal, Teflon bushing, 10-vane rotor/slide assembly, Trans-Go steel rings & priming spring, special heavy duty pressure regulator valve, Trans-Go HD pressure regulator spring, .296 intermediate/reverse boost valve, .500 main boost valve, both halves of pump machined flat with rotor to pump clearance set at .0015"-.0025", and new stator support.

Reverse Input Drum: A reworked or new reverse/input drum, along with the Turbulator low-drag steels, and Borg Warner clutches. The Belville spring is replaced with a waved spring, this eliminates the Belville spring from eating the reverse/input drum.

Input Drum: New latest design 29 element input sprag, Borg Warner clutches for the overrun and forward clutch assemblies, 7 .080 Borg Warner Hi-Energy clutches along with 6 .096 Lyndar (heat treated) steels used in the 3-4 clutch pack, Trans-Go (Hi-Rev) heavy duty springs replace the OEM 3-4 and forward springs and 3-4 helper springs (the Trans-Go springs prevent the 3-4 clutches from getting into trouble, due to centrifugal clutch apply. Good for up to 7,800 rpm, stock setup starts getting into trouble around 5,000 rpm), clearance for the 3-4 clutch pack .045-.055, a Viton input to output shaft seal is used, the Viton is soft (will withstand 650 degrees F.) and will conform to the output shaft thereby guaranteeing oil to the rear planet.

Rear Drive Section: Hand picked input sun gear, forward planet with batwing thrust washers, input internal gear, reaction carrier shaft, a new Sealed Power "Beast" sun shell, low/reverse support, the latest design Borg Warner low/reverse roller assembly, Turbulator low-drag steels, Borg Warner clutches, hand picked or new rear planet, hand picked reaction sun gear, internal reaction gear, internal reaction gear support, a bronze rear case bushing, new governor ear, and a Teflon extension housing bushing and a Vamac (prelubed) rear seal.

2-4 Band & 2-4 Servo: Borg Warner Hi-Energy 2-4 band, new Corvette 2nd gear apply servo used in conjunction with the latest design Viton seals. An additional spring is added to the cushion side of the servo to help provide a smoother 1-2 apply at light throttle while still allowing a firm WOT shift.

Valve Body: We use the Trans-Go Performance Shift kit in conjunction with the large boost valves, Corvette servo, and the 7 clutch 3-4 pack. We work with the accumulators to give the best possible part throttle shifts, and progressively firmer shifts with more throttle opening. A Sealed Power (zero-leak) filter is used.

The Case: We use the 1988-1992 transmission to start our builds with unless a special request to do otherwise.

Details


Part Number	700RR
Price:	$1,595.00

Options

Engine Type

Quantity

Add to cart